Previous Table of Contents Next

 

QUANTUM MAVERICK 270S, 540S

QUANTUM PRODRIVE LPS 127S, 170S, 340S

Interface: SCSI-2
Size: 3.5 third height
View: Bottom

DRIVE SELECTION
Drive Number A0 A1 A2
0 open open open
1 closed open open
2 open closed open
3 closed closed open
4 open open closed
5 closed open closed
6 open closed closed
7 closed closed closed

 
MISCELLANEOUS TECHNICAL NOTES
Jumper J13 is factory configured - do not alter

 

QUANTUM PIONEER SG 1080AT, PIONEER SG 2110AT

Device Type Hard Drive
Interface Fast-ATA
Size 3.5 in. third height
View Bottom

DRIVE CONFIGURATION
Setting JP1/A JP1/B
Drive is master closed open
     Drive is slave open open
     Master/Slave determined by Cable Select open closed
Note: JP1/C is declared as "parking position" and should be used to store spare jumpers.
Note: JP1/D is declared as "reserved" and should be left open.

 

QUANTUM PRODRIVE 525S Rev. 1, PRODRIVE 1800S

QUANTUM PRODRIVE LPS 525S

Interface: SCSI-2
Size: 1800S: 3.5 in. half height
525S: 3.5 in. third height
View: Bottom

DRIVE CONFIGURATION
Drive Number Jumper A0 Jumper A1 Jumper A2
     0 open open open
     1 closed open open
     2 open closed open
     3 closed closed open
     4 open open closed
     5 closed open closed
6 open closed closed
     7 closed closed closed

 
USER CONFIGURABLE SETTINGS
Function Location Setting
SCSI parity check enabled EP closed
     SCSI parity check disabled EP open
Flash memory programming disabled FL open
     Flash memory programming enabled FL closed
TERMPWR supplied by drive J13 open
     TERMPWR supplied by the SCSI interface pin 26 J13 closed
Spindle motor synchronization disabled SY open
     Spindle motor synchronization enabled SY closed
SCSI termination enabled TE closed
     SCSI termination disabled TE open
Spindle motor starts on power-up WS open
     Spindle motor starts on command only WS closed

 
MISCELLANEOUS TECHNICAL NOTES
a)  All unlabeled jumpers are factory-configured - do not alter.
b)  Jumpers WS, A0, A1, A2, and SY are available in more than one location on this board.
Do not install a jumper for any of these at more than one location at a time.
c)  Jumper SS is factory configured - do not alter.

 
Previous Table of Contents Next